Use the tip of your screwdriver to gently move the edges of the sponge away, and from under tabs. Keep doing this procedure until you can see the sponge is good and wet. Start dabbing up the ink with clean Q-Tips. Or, keep wetting the small area until it is good and wet. If you are careful, you can actually scrape a bit of this dried sludge unto the tip of your screwdriver, then wipe the sludge off the tip with a paper towel. You want to get the ink sludge to more of a liquid state to help remove it. First get a Q-tip and soak it with some spray cleaner, such as 409 or Fantastic. Let me say here that these sponges are quite thin and fragile, so you must be very careful. You will see two black areas where these sponges sit. (Anytime I try to partially disassemble a case like this, things start falling out and I can never get it put back together!). Unfortunately, I do not know of a way to partially disassemble the printer to provide better access to these sponges, hence the long screwdriver and tweezers. True, your problem may be elsewhere, but at the very least, you need to thoroughly clean these sponges before giving up or before giving to a repair guy. These sponges, located on the far left and far right of the carriage, are what clean and wipe your nozzles. What happens over many months of usage is that two or three small sponge pads become soaked with black ink, then partially dries to a sludge. A pair of latex gloves is a good idea to avoid getting ink all over your hands….it will happen! The screwdriver I used was from a set of specialized jewelers screw drivers, the head should be no wider than 1/8th of an inch. Second, you will need a LOT of Q-Tips a small flashlight (head-mounted style works best) a pair of LONG tweezers and a long, thin, small-bladed screwdriver. The following procedure can be somewhat messy, so you really need to first unplug the printer ad place it on a good work table with a towel underneath it. I think it’s much better to spend a couple of hours fixing your own printer than waiting weeks for its return. So I thought I would pass this info along to those who might use it. #Epson stylus photo r1800 print utility how to#I have taken it in for printing problems in the past, and the service guy took the time to show me what normally happens with these printers, and how to fix them myself. However, it IS a pricey printer and the ink cartridges are small and expensive. I have owned a couple of the Epson Photo Stylus R1800 printers, and have always been happy with the results when it was working properly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |